SEBURO MN-23 - Attaching Lower Mount Base and Tactical Light and Laser Sight
Destination
Attaching STREAMLIGHT's M6 on MN-23
Operation
Fitting a lower mount base
STREAMLIGHT's M6 had been arrived from my friend emigrating overseas.
Cut a gash on the Fore Grip to install M6 so as to operate it by left hand.
Screw cramp the mount base - diverted from MN-23's Mount Base(What a waste!) - on the Fore Grip.
Apply putty to over-grind spot, then re-mold it.
A halfway looks appear, the mount base edge throw out only 3mm from the Fore Grip, when try to make clearance between M6 and the Fore Grip.
Looks uncool... So make the edge in plane with the Fore Grip by adhibiting 3mm thickness cellular PVC board in front.
Then glue on velour material, and paint the muzzle guard and the mount base.
The muzzle run short of length, since 3mm thickness PVC board attached. Make Muzzle for M6.
Installation M6
Install M6.
It looks misaligned optic axis and shooting axis cause of close-up picturize, but they are parallel-veined actually.
Also seems like not spoiling MN-23's image without M6.
But looks not so good without M6. Make a Mount Rail Cover.
Roll paper clay over the mount area directly yet again, then remove it after dry up. Cut and shape the clay. And paint the backside matt black, stick velour sheet.
The bulge is highly visible in front view.
The side view has been natural look.
Holding like this.It may not need remote switch becase the switch is able to operate by left hand. And Mode Switch also is on easy operating position. They are one of the advantage of Bull Pup design.
Take a picture with night photography mode of digital camera.Of course smoked by baccy to see light ray.:-)
This is full geared MN-23!!Please refer Several barrel and silencers !
M6 position is more close than rendering. But, Wooom, this hit hard my fancy!!
Well, I made a wallper.