SEBURO MN-23 - Rubber Coating Grip
Destination
Upgrading hold facility of the grip
Operation
Sense of discomfort lies on the grip, especially third finger, cause of that MN-23's grip is bit slim and has a horn(?) in the center of its.
It seems like rubber coat that hatched area around the grip in the original design with playing of the imagination. And extrapolate much, decided to attache a rubber grip.
Roll paper clay over the body directly, then remove it after dry up. I prefer Paper clay cause of it doesn't cling to host material without molding lubricant.
Cut and shape the clay, then put splay (MEDICOM SUPER RUBBER SPLAY SMOKE) on it. Back side is painted flat black for water-resistant, because getting wet makes paper clay liquid.
Attached shown in the left. Since its position is restricted by its top and bottom ends, it seems no need to fix by screw. But should be better to fix by screw, when chase about in open air with this over-the-shoulder.
Holding facility has been much better when brandish and pull the trigger. Looks not so good, being as no pattern on the rubber grip as like checkering or grooving. I may do something about its appearance next time.
Accordingly, groove on the fringe of the rubber grip. Then affix a mesh that enclose a kitchen soap pad.:-)Adhere pivotal points by instant glue. After that put splay (MEDICOM SUPER RUBBER SPLAY SMOKE) on it.
Make fixing top and bottom edges for that its lost will make me trifle sad.Lay fixing nuts inside of trigger guard in the front, and inside of the grip after applied putty.
Looks bit gaudy, but better than smooth and flat...